Indian boardtrack forks Part 1
Original fork blades were tapered and curved. I use oval tubing 30 x 16mm. Basically its a ERW 1" tube that's been formed in oval dies....
top of page
Paul Darby
- Dec 19, 2022
- 2 min
Indian boardtrack replica machining and fabrication
Tube selection is paramount to the build. You need to consider the weight that it will carry. Mainly you're choice of engine will...
57 views0 comments
Paul Darby
- Dec 19, 2022
- 1 min
Indian boardtrack replica machining and fabrication
Introduction In this blog I intend to guide you through the way I build a Boardtracker. From the selection of tube to welding, braizing,...
53 views0 comments
Paul Darby
- Dec 15, 2022
- 1 min
Yamaha Vmax restoration Part 8:
I sandblasted the rear brake carrier and Cerakoted in clear. I used C Series which is high temperature but air drying. I then fitted the...
49 views0 comments
Paul Darby
- Nov 26, 2022
- 1 min
Yamaha Vmax restoration Part 7 (V-boost):
Next is the v-boost unit. Pretty straightforward as it was just a matter of taking it all apart. I didn’t try to remove the butterflies,...
60 views0 comments
Paul Darby
- Nov 26, 2022
- 1 min
Yamaha Vmax restoration Part 6 (Wheels and Swingarm):
Tyres refitted, balanced and new 90° tyre valves were used. Discs were refitted with new bolts and I fitted new wheel bearings and dust...
38 views0 comments
Paul Darby
- Nov 26, 2022
- 1 min
Yamaha Vmax restoration Part 5 (Fork yokes and Wheels):
Fork yokes fitted with new bearings and dust seals. I must say that the bottom race was difficult to get off. I resorted to cutting...
37 views0 comments
Paul Darby
- Sep 13, 2022
- 1 min
Yamaha vmax restoration
The engine is all painted and I'm well happy. I masked off the bare aluminium surfaces, which will be polished and lacquered in due...
7 views0 comments
Paul Darby
- Sep 12, 2022
- 1 min
Yamaha vmax restoration
Frame is back from the powder coaters and I'm well pleased. I protected all the surfaces and cleaned ot the threads. Got some zinc...
3 views0 comments
Paul Darby
- Sep 11, 2022
- 1 min
Yamaha vmax restoration
Engine mounted on stand, heads, pump and all covers removed in preparation for painting. Had to remove the clutch basket in order to...
3 views0 comments
Paul Darby
- Sep 9, 2022
- 1 min
Yamaha vmax restoration Part 2
Frame completely stripped and photographed. I've kept most bolts and nuts with each component. Where I haven't been able to, I've...
5 views0 comments
Paul Darby
- Sep 8, 2022
- 1 min
Yamaha vmax restoration Part 1
I am undertaking a full restoration of a 1998 full power Yamaha vmax. The bike has done a little over 25,000miles and is a UK bike. The...
20 views0 comments
bottom of page